Medisana CardioCompact 51098 사용자 설명서

제품 코드

51098

3 Getting started

3.5 Set alarm

Adjust the display tilt angle in that way, that the marking of the tilt
mechanism

indicates “Travelling clock mode”.

Press and hold the SNOOZE-button

for at least approx. 2

seconds, until the alarm state of the first alarm

flashes (ON

or OFF).
Press the MEM-button

to change the state of the alarm. You

can select ON (activates alarm) or OFF (deactivates alarm).
Press the SNOOZE-button

to continue with the next step.

Follow the same steps (MEM-button

to adjust, SNOOZE-but-

ton

to continue with the next value) to enter the correct values

for hour and minute.
After that, you may enter a second alarm time

according to the

same scheme.
You may leave the alarm setting mode at any time by pressing
the START-button

. After approx. 1 minute without pressing any

button the device automatically leaves the alarm setting mode.
If the batteries are removed, these values are lost and need to be
input again.

•

NOTES:

- The alarm only will be effective in Travelling
clock and blood pressure measurement modes
(not in OFF mode).
- The alarm settings are only referring to the
regular clock - even if a second time zone

has been set according to chapter 3.4 Set date
and time.
- Press “MEM”

or “START”

to stop the

alarm or press the “SNOOZE”-button

and the

device will alarm again after 10 minutes.
- If no button is pressed within 50 seconds
during alarming, the alarm will be paused and
will alarm again after 10 minutes. If still no
button is pressed after 5 of the procedures, the
alarm will be cancelled.

51098 Travel GA West AM Master.indd 38

27.09.2012 12:29:18