E-flite UMX Carbon Cub SS BNF EFLU1180 사용자 설명서

15

NOTICE: Removing tape or decals may remove 
paint from the fuselage.

CAUTION: DO NOT handle propeller parts 
while the fl ight battery is connected. 
Personal injury could result.

 

1.  Remove the spinner (A) from the propeller (B).

Since the propeller and spinner are glued 
together, glue residue will need to be cleaned 
from the spinner or propeller when these parts 
are used again.

2.  Carefully remove the screw (C) and propeller 

(B) from the motor shaft (D).

A propeller spacer is installed on the motor 
shaft. Take care to not lose the spacer; it 
is needed to correctly install the propeller.

Tip: When the fuselage needs to be opened for 
access to the motor, servos or receiver, cut the tape 
or decals to open the fuselage. See “Opening 
the Fuselage”.

1.   Remove 2 screws (E), the firewall (F) and 

motor (G) from the fuselage motor 
mount (H).

The motor magnet may attract screws 
to the motor.

2.  Remove the top screw (I) from the firewall 

(F) and motor (G).

3.  Disconnect the motor wire connector from 

the ESC/receiver connector.

Motor and Firewall
1.  Connect the motor wire connector to the ESC/

receiver connector so the wire colors align.

2.  Install the motor in the firewall using a screw 

in the top of the firewall. 

3.  Attach the firewall to the fuselage motor mount 

using 2 screws.

Propeller
1.  Install the propeller on the motor shaft using 

a screw. The numbers on the propeller must 
face out from the fuselage for correct propeller 
operation.

2.  Install the spinner on the propeller using foam-

compatible CA.

3.  Put the foam battery hatch on the fuselage and 

slide it back to fully engage the fuselage.