Reely 1:10 Electric monster truck model car Audi RS6 4WD P-190 RtR 2.4 GHz QCO1014W000F17SR02 데이터 시트
제품 코드
QCO1014W000F17SR02
39
• Switch the receiver on with the switch on the cover of the RC box. Now the servos should move to neutral position.
Always proceed in the correct sequence when turning the transmitter and receiver on or off!
Switching on: Always switch on the transmitter first, then the receiver.
Switching off: Always switch off the receiver first, then the transmitter.
Switching on: Always switch on the transmitter first, then the receiver.
Switching off: Always switch off the receiver first, then the transmitter.
i) Failsafe Function
To control the vehicle when reception is poor or the receiver battery is low, your remote control is equipped with a fail-safe function. The fail-safe function controls
the throttle/break servo.
Before to the first drive, this failsafe function must be programmed for the correct position of the throttle/brake servo (observe the remote control’s operating
instructions).
The programmed fail-safe position must ensure that to motor is throttled back and the brake is activated.
the throttle/break servo.
Before to the first drive, this failsafe function must be programmed for the correct position of the throttle/brake servo (observe the remote control’s operating
instructions).
The programmed fail-safe position must ensure that to motor is throttled back and the brake is activated.
j) Checking the Range of the Remote Control Transmitter
In order not to lose control over your model you should, before each first start or after a crash, check the function and range of the RC system. For the range test,
it is sufficient to test the function of the steering servo.
Support the model at the front axle in a way that allows the wheels to hang freely.
Due to the good traction of the wheels and the weight of the vehicle, the wheels would not follow your steering commands spontaneously and directly while the
wheels stand still on the floor. This changes during operation.
it is sufficient to test the function of the steering servo.
Support the model at the front axle in a way that allows the wheels to hang freely.
Due to the good traction of the wheels and the weight of the vehicle, the wheels would not follow your steering commands spontaneously and directly while the
wheels stand still on the floor. This changes during operation.
Only perform the range test when the combustion engine is not running!
• First, switch on the transmitter and then the receiver.
• Move approx. 50 m away from the model.
• Move the steering wheel (channel 1) to the right. Now the wheels must turn to the right!
• Move the steering wheel to the left. Now the wheels must turn to the left!
• Release the lever of the remote control. The wheels must turn back into the straight drive position.
• Move approx. 50 m away from the model.
• Move the steering wheel (channel 1) to the right. Now the wheels must turn to the right!
• Move the steering wheel to the left. Now the wheels must turn to the left!
• Release the lever of the remote control. The wheels must turn back into the straight drive position.
Never drive the model with a remote control that is not functioning properly!
If the remote control does not function properly, first check the charge status of the transmitter and receiver batteries and make sure that nobody uses the same
frequency as you.
If the problem persists, consult the troubleshooting table.
frequency as you.
If the problem persists, consult the troubleshooting table.