Reely Electr. single-rotor helicopter RtF (mSP190) mSP190 데이터 시트

제품 코드
mSP190
다운로드
페이지 112
38
10.    Operation of the Model Helicopter
a) Charging the Flight Battery
The flight battery (see figure 4, item 1) can be charged 
either with the USB charging socket of the transmitter 
(see figure 1, item 5), via a USB socket at a computer/
notebook or at a commercial USB plug-in charger. In 
any case, the enclosed USB charging cable must be 
used for this (see figure 4, item 2).
Connect the flight battery (1) with the connector protec-
ted against polarity reversal of the USB charging cable 
(3). Work with the required care and do not apply any 
unnecessary force. Then connect the USB plug of the 
charging cable (4) to the transmitter according to the 
lower illustration in figure 4.
For photo-technical reasons, the USB charging cable 
is illustrated in the wound-up state in figure 4. Before 
first use, the cable retainer should be opened and the 
cable unwound.
Turn on the transmitter with the on/off switch (see figure 
1, item 6).
The LED display at the transmitter (also see figure 1, 
item  10)  is  lit  red  first  and  starts  flashing  green  after 
approx.  3  seconds. The  charging  display  in  the  USB 
plug (5) of the charging cable remains lit red. The light 
battery is now being charged.
When  charging  is  completed,  the  LED  display  at  the 
transmitter remains lit green and the charge indicator in 
the USB plug of the charging cable goes out.
Disconnect the rechargeable battery (1) from the char-
ging cable (2) right away then and pull the USB plug (4) 
from the USB charging socket of the transmitter. Then 
switch off the transmitter again.
If the flight battery is connected to a computer or a USB 
plug-in charger for charging, only the charging control 
display in the USB plug of the charging cable (see fi-
gures 4 and 5, each item 5) is used to visually display 
charging.  If  the  LED  display  goes  out,  charging  has 
been completed and the flight battery must be discon-
nected from the charging cable and the charging cable 
from the computer or the USB plug-in charger.
Figure 4
Figure 5