Viessmann 4516 H0 H0 Track busy signal of DB in compact design 4516 데이터 시트
제품 코드
4516
4
Fig. 3
Abb. 3
Fig. 4
90°
15 mm
15 mm
Ø 6 mm
Abb. 4
Fig. 2
Abb. 2
Sh0 (Rangierverbot)
Sh0 (shunting prohibited)
Sh1 (Rangierverbot aufgehoben)
Sh1 (shunting allowed)
blaues Kabel mit roter Markierung
blue cable with red marking
blaues Kabel mit grüner Markierung
blue cable with green marking
5. Montage
1) Prüfen Sie vor dem Einbau des Signals, wie im
Punkt „Funktionskontrolle“ beschrieben, des-
sen einwandfreie Funktion.
2) Beschriften Sie das Signal gemäß den Hinwei-
sen auf Seite 3.
3) Sägen Sie an der Montagestelle ein Loch mit
den Maßen 15 mm x 15 mm. Bohren Sie dazu
zuerst 4 Löcher mit 6 mm Durchmesser. Ver-
wenden Sie die in der Abbildung 3 abgedruckte
Schablone.
4) Führen Sie die Anschlusskabel von oben durch
das Montageloch und stecken Sie dann das Si-
gnal mit dem Antrieb voran hinein.
5) Halten Sie die Bodenplatte des Signals jetzt
von oben fest. Schieben Sie den Befestigungs-
ring von unten so auf den Antrieb, dass die
Rastnasen um 90° zu der Riffelung am Gehäu-
se des Antriebes verdreht sind. Wenn nun die 4
Kunststofflaschen des Befestigungsringes mit
der Anlagenplatte unter mechanischer Span-
nung stehen, drehen Sie den Ring so, dass die
Nasen in der Riffelung des Antriebsgehäuses
für einen festen Halt sorgen.
5. Mounting
1) Check that the signal works properly as per the
instructions above before you start installing it
on the layout.
2) Letter the signal in accordance with the instruc-
tions on page 3.
3) Saw a square hole of 15 mm x 15 mm at the
mounting place. But before 4 holes of 6 mm di-
ameter each should be drilled in the corners.
Please use the pattern which is shown in figure
3.
4) The signal‘s connection wires have to be insert-
ed into the hole first. After that put the signal
with the drive first into that hole.
5) Now the base plate of the signal has to be held
in place (perhaps by a second person). Then
push the mounting ring from below onto the
drive in such a manner that the tabs are at a
right angle to the groves on the housing of the
drive. Once the 4 plastic tabs of the mounting
ring are under tension, you turn the ring until
the tabs lock against the groves on the hous-
ing.