3D Systems 350166 데이터 시트

34

If you are not connected to a network, you can download your creations from your computer and save them to your USB memory 

stick for printing.
•

When printing with the USB memory stick, the file must be in the main folder located on the memory stick. If it is put into

another folder it cannot be accessed from Cube screen.

•

Install your USB memory stick into your computer’s USB connection and save your creation to your USB memory stick.

•

When you are ready to print your creation, install your memory stick into the Cube’s USB connection and print your cre-
ations. 

2.  If your USB memory stick is connected to the Cube, please remove the memory stick, (the screen will display the directions 

to do this). Tap the “NEXT” arrow on the display;  locate the USB cable and connect the cable to the Cube USB port located 

on the back of the Cube (again, these instructions will be displayed on the screen). Connect the other end of cable to your 

computer’s USB port. 

NOTE: Never leave the USB cable connected except when upgrading the firmware

3.   Tap the “NEXT” arrow.  “SETTINGS SAVED” will be displayed at the top of the screen.  You will have 6 seconds to press 

and hold the control button until firmware loader appears on the screen. If the button is released before the firmware screen

appears, the screen will go blank. Repeat “Step1” to restart the update firmware process.

1.  Tap on “Setup” on the Cube touch screen and scroll to “Update Firmware.” Finger tap “Update Firmware.”