3D Systems 350166 데이터 시트

4. Continue to hold button until “Settings Saved” and then “Cube Firmware Loader XX” appears on the touch screen.

You are now in the correct mode to update your firmware.

NOTE: Be sure to disconnect the USB cable after you have

updated your firmware.

5. Open Cubify Software and click the “Configure” icon; click on “Load New Cube Firmware.” Once you see the pop-up mes-

sage “Firmware Updated Successfully”, click OK.

6. Disconnect the USB cable from your Cube and computer; unplug the Cube power cord. Plug power cord back in and

press the Cube power button; a message will display on the touchscreen “Setting restored,” click on the check mark to

save settings. This does not change your previous settings that you have made. Your new firmware is now installed.