Benq TW526 9H.JCH77.14E 데이터 시트

Maintenance

48

Timing of replacing the lamp

When the Lamp indicator lights up red or a message appears suggesting it is time to 

replace the lamp, please consult your dealer or go to 

http://www.BenQ.com 

before 

installing a new lamp. An old lamp may cause a malfunction in the projector and in some 

instances the lamp may explode. 

The LAMP indicator light and TEMPerature warning light will light up if the lamp becomes too hot. 

Turn the power off and let the projector cool for 45 minutes. If the Lamp or Temp indicator still lights up after 

turning the power back on, please contact your dealer. See 

 for details.

The following Lamp warning displays will remind you to change the lamp.

"XXXX" shown in the above messages are numbers that vary depending on different models.

Install a new lamp for optimal performance. If the 

projector is normally run with Economic 

selected (See 

), you may continue to operate the 

projector until the next hour lamp warning 

appears.

Press MODE/ENTER to dismiss the message.

It is strongly recommended that you replace the 

lamp at this age. The lamp is a consumable item. 

The lamp brightness diminishes with use. This is 

normal lamp behavior. You can replace the lamp 

whenever you notice that the brightness level has 

significantly diminished.

Press MODE/ENTER to dismiss the message.

The lamp MUST be replaced before the projector 

will operate normally.

Press MODE/ENTER to dismiss the message.

Lamp>XXXX Hours

Order a new lamp at www.BenQ.com

Lamp>XXXX Hours

Order a new lamp at www.BenQ.com

Lamp>XXXX Hours
Lamp usage time exceeded

Order a new lamp at www.BenQ.com

Replace lamp (Refer to user manual)
Then reset lamp timer
Order a new lamp at www.BenQ.com