Bosch NIT5665UC 사용자 매뉴얼
17
Maintenance
This appliance requires no maintenance other than daily
cleaning. For best results, apply cooktop cleaning cream
daily.
Service
Troubleshooting
If you encounter a problem, it often will merely be
something minor. Before you call customer service,
consider the suggestions and instructions below:
9
CAUTION
Repairs should only be done by a trained servicer.
Improper repair of your appliance may result in risk
Improper repair of your appliance may result in risk
of severe physical injury or death.
--------
Fault
Possible cause
Measure
Cooktop is not working The electric power supply has been
interrupted.
Use other electrical appliances to check if there has
been a power outage. Check to see if there is a prob-
lem with the circuit breaker for the electrical installa-
tion.
The appliance has not been cor-
rectly connected following the con-
nection diagram.
Make sure that the appliance has been connected
correctly.
Electronic system malfunction.
Contact the Technical Assistance Service.
“
is flashing on the ele-
ment display
The touch control zone is wet, very
dirty, food has boiled over, or an
object is lying on top of the touch
control zone.
Clean the touch control zone, or remove the object.
Lightly touch the corresponding touch key. The flash-
ing should stop.
“
flashes on all ele-
ment displays. An
accoustic signal
sounds
The main switch has been activated
continuously for more than 5 sec-
onds.
Press the power key again. Reset the cooktop.
The cooktop turns off
by itself
The main switch has been touched
unintentionally.
Press the main switch again. Reset the cooktop.
The display flashes (no
power) when you place
a pan on an induction
element
The pan is not ferromagnetic
Check the bottom of the pan with a magnet.
The diameter of the pan is to small. Use a pan with an appropriate diameter for the ele-
ment.
If the display still does not light up when you turn the
If the display still does not light up when you turn the
element off and on again, disconnect the appliance
at the circuit breaker. Wait 20 seconds and then
reconnect it.
The SpeedBoost func-
tion display flashes and
then turnes off
The element is too hot.
The SpeedBoost function operates the element with
the highest possible power. During long cooking
times, it is possible that the function will turn the ele-
ment off to protect the cooktop from overheating. You
can continue to use the cooktop if the display is not
flashing.
Display
“
and numbers A fault in the electronic system has
occurred.
Turn the appliance off and back on at the fuse or cir-
cuit breaker. If the same fault occurs again, discon-
nect the appliance and call Technical Assistance
Service.
Display
”
and numbers A fault has been detected.
The following table of error messages lists actions
you can take to correct the problem