BENDIX SD-13-4767 사용자 설명서
3
FIGURE 2 - POWER LINE WITHOUT PLC SIGNAL
FIGURE 3 - POWER LINE WITH PLC SIGNAL
Suggested oscilloscope settings are (AC coupling, 1 volt/
div, 100 μsec/div). The signal should be measured on pin
7 of the J560 connector at the nose of the trailer.
div, 100 μsec/div). The signal should be measured on pin
7 of the J560 connector at the nose of the trailer.
PIGTAIL WIRING HARNESSES
Several pigtail wire harnesses are available to connect
the TABS-6 module with ABS and other trailer system
components. Pigtail harness are weather sealed at the
connector interface and are clearly labeled for proper
installation. Because of the over-molded design of the
TABS-6 module wiring harnesses, Bendix recommends that
the complete harness be replaced if damage or corrosion
occurs.
the TABS-6 module with ABS and other trailer system
components. Pigtail harness are weather sealed at the
connector interface and are clearly labeled for proper
installation. Because of the over-molded design of the
TABS-6 module wiring harnesses, Bendix recommends that
the complete harness be replaced if damage or corrosion
occurs.
The following connector options may be present:
Modulator 2 (MOD2), Modulator 3 (MOD3), auxiliary,
diagnostic, and additional axle wheel speed sensors.
diagnostic, and additional axle wheel speed sensors.
Note: All TABS-6 modules include the two primary wheel
speed sensor connections and therefore these are separate
from the pigtail harness.
speed sensor connections and therefore these are separate
from the pigtail harness.
ECU Connectors
Standard TABS-6 module ECU connectors use a TTMA
97-99 5-pin Packard Weather Pack connector for brake
light power, constant power, ground, the trailer-mounted
ABS indicator lamp and a single auxiliary input/output (I/O).
97-99 5-pin Packard Weather Pack connector for brake
light power, constant power, ground, the trailer-mounted
ABS indicator lamp and a single auxiliary input/output (I/O).
Premium TABS-6 module ECU connectors use an 18-pin
Deutsch DT series connector for the same function as
above, plus additional modulators, wheel speed sensors
and auxiliary I/O’s.
Deutsch DT series connector for the same function as
above, plus additional modulators, wheel speed sensors
and auxiliary I/O’s.
FIGURE 4 - EXAMPLES OF PIGTAIL WIRE HARNESSES AVAILABLE
Premium Pigtail Harness
(4S/2M with diagnostic)
18-Pin ECU Connector
2-Pin Additional
Wheel Speed
Sensor
Connectors
(SAL & SAR)
4-Pin Diagnostic
5-Pin Power and
Indicator
Lamp (POWER/
WL)
3-Pin Modulator 3
(MOD3) (Optional)
3-Pin Modulator 2
(MOD2)
Auxiliary
(Optional)
5XXX...
To ECU or Pigtail
To TABS-6 Module
Pigtail
To Diagnostic
Tool
5XXX...
E
B
A
D
C
5XXX....
5-Pin Power and
Indicator Lamp
(POWER/WL)
5-Pin ECU
Connector
To TABS-6 Module
Pigtail
To BR9235
™
ABS Modulator
Relay Valve
Optional
Diagnostic
To WS-24
™
Wheel
Speed Sensor
Standard Pigtail Harness
(2S/1M) with optional diagnostic
Modulator Extension Harness
Wheel Speed Sensor
Extension Harness
Diagnostic Tool Harness