BENDIX SD-13-4767 Manuel D’Utilisation

Suggested oscilloscope settings are (AC coupling, 1 volt/
div, 100 μsec/div). The signal should be measured on pin 
7 of the J560 connector at the nose of the trailer.

Several pigtail wire harnesses are available to connect 
the TABS-6 module with ABS and other trailer system 
components.  Pigtail harness are weather sealed at the 
connector interface and are clearly labeled for proper 
installation.  Because of the over-molded design of the 
TABS-6 module wiring harnesses, Bendix recommends that 
the complete harness be replaced if damage or corrosion 
occurs.

The following connector options may be present: 

Modulator 2 (MOD2), Modulator 3 (MOD3), auxiliary, 
diagnostic, and additional axle wheel speed sensors. 

Note: All TABS-6 modules include the two primary wheel 
speed sensor connections and therefore these are separate 
from the pigtail harness.

Standard TABS-6 module ECU connectors use a TTMA 
97-99 5-pin Packard Weather Pack connector for brake 
light power, constant power, ground, the trailer-mounted 
ABS indicator lamp and a single auxiliary input/output (I/O).

Premium TABS-6 module ECU connectors use an 18-pin 
Deutsch DT series connector for the same function as 
above, plus additional modulators, wheel speed sensors 
and auxiliary I/O’s.

5XXX...

5XXX...

E

B

A

D

C

5XXX....