Western Telematic PTS-8NE15-1 사용자 설명서

If Secure Racked units are installed in a closed or multi-unit rack assembly, they may require further 

evaluation by Certification Agencies.  The following items must be considered.

1.  The ambient within the rack may be greater than room ambient.  Installation should be such 

that the amount of air flow required for safe operation is not compromised.  The maximum 

temperature for the equipment in this environment is 55°C.  Consideration should be given to the 

maximum rated ambient.

2.  Installation should be such that a hazardous stability condition is not achieved due to uneven 

loading.

Check nameplate ratings to assure there is no overloading of supply circuits that could have an effect 

on overcurrent protection and supply wiring.

Reliable earthing of this equipment must be maintained.  Particular attention should be given to 

supply connections when connecting to power strips, rather than direct connections to the branch 

circuit.

Do not attempt to repair or service this device yourself.  Internal components must be serviced by 

authorized personnel only.

If any of the following events are noted, immediately disconnect the unit from the outlet and contact 

qualified service personnel:

1.  If the power cord becomes frayed or damaged.

2.  If liquid has been spilled into the device or if the device has been exposed to rain or water.

Note that PTS Series units feature two separate power circuits, and a separate power supply cable for 

each power circuit.  Make certain to disconnect both power supply cables before attempting to service 

or remove the unit.

Depending on your specific model, PTS Series units may be shipped with either one or two 125 VAC, 

15 Amp "Starter" Cables.  These Starter Cables will allow you to connect the PTS to power for bench 

testing and initial start up and are adequate for applications that only require 15 Amps.  For 20-Amp 

power switching applications, please refer to the WTI Power Cable guide supplied with the unit, or 

use appropriate 20-Amp cables.

For units with fixed Power Cords the socket-outlet shall be installed near the equipment and shall be 

easily accessible.