Western Telematic PTS-8NE15-1 사용자 설명서

This Quick Start Guide describes the installation procedure for the PTS series 

hardware.  The PTS is essentially a power fallback switch, that automatically 

switches power from a primary input to a secondary input when power to the 

primary input is lost or interrupted.

Apply Power to the MPC
Refer to the warnings and cautions at the beginning of this guide and the 

power rating nameplate on the PTS back panel, and then connect the unit to 

two appropriate power sources.  For units with detachable power input cables, 

connect the power input cables to the power inlets, install the cable keepers, and 

then connect the primary power input cable to your primary power supply and 

the secondary power input cable to your secondary power supply.  Refer to the 

table below for information concerning power requirements and maximum loads.

PTS-8NE15-1

15 Amps

100 to 120 VAC

12 Amps

8 ea. NEMA 5-15R

12 Amps*

PTS-9CM20-2

20 Amps

200 to 240 VAC

10/16 Amps

8 ea. IEC-60320-C13 

1 ea. IEC-60320-C19

16 Amps*

*  In accordance with UL requirements, this value has been de-rated to 80%.

•  PTS-8NE15-1:  Two (2) IEC-60320-C14 Inlets.
•  PTS-9CM20-2:  Two (2) IEC-60320-C20 Inlets.

•  After connecting your power cables to the PTS unit, make certain to 

secure the cables in order to prevent accidental disconnection.

•  PTS-1 series units are designed for switching power input lines that 

are typically 120 VAC.  If a power input lower than 120 VAC is 

connected to a PTS-1 unit, then power switching features will not 

function correctly.

•  PTS-2 series units are designed for switching power input lines that 

are typically 240 VAC.  If a power input lower than 240 VAC is 

connected to a PTS-2 unit, then power switching features will not 

function correctly.