Sony Water Dispenser 2 사용자 설명서

229

Setup Relating to Operations From the Control Panel

  

Ch
apt

er 16 

E

ngin

eering Se

tup

The status area shows a list of the items with their settings.

Make the following settings as required.

Effect recall mode: To select the state of the first keyframe when an effect 

is recalled, select [Recall] (the first keyframe is not recalled) or 
[Recall&Rewind] (the first keyframe is recalled) in the <Recall 
Mode> group.

Automatically turning [EDIT ENBL] off: When an effect is recalled 

with the [EDIT ENBL] button on, to automatically turn this button off, 
disabling keyframe editing, turn [Edit Enable Auto Off] on.

Automatic first keyframe insertion: When an empty register is recalled, 

to automatically insert a first keyframe of the state at that point, turn 
[1st KF Auto Insert] on.

Automatic effect saving: To automatically save an effected when it is 

recalled after being edited, turn [Effect Auto Save] on.

Keyframe duration default value: Press [Default KF Duration], then 

enter the default value from the numeric keypad window.

For P-Bus, GPI, and DDR/VTR timeline operations, to execute the first 
keyframe when a rewind is carried out, set each external device on in the 
<REWIND&1st KF> group.

When an effect is executed by pressing the [RUN] button with this setting on, 
the first keyframe action is not executed.

GPI: setting for the GPI timeline
P-Bus: setting for the P-Bus timeline
DDR/VTR: setting for the VTR/disk recorder timeline

To set the Source and Destination names used in the control panel, use the 
following procedure.

In the <Source/Dest Name> group of the Panel>Operation menu, select the 
names to be used from the following.

SW’er Local: Source names set in the Xpt Assign menu, and fixed bus 

names

S-Bus Descript: Description names set in the routing switcher
S-Bus Type + No.: Type + No. set in the routing switcher (In this case 

always eight characters.)