Visioneer DP1011 사용자 설명서
Xerox DP1011 User’s Guide
21
Maintenance
Maintenance
Changing the Lamp
The projector’s lamp life is approximately 1500 hours of use. The
projector automatically monitors the lamp life. After 1500 hours of
use, the projector displays the message:
projector automatically monitors the lamp life. After 1500 hours of
use, the projector displays the message:
The Lamp has been in use for over 1500 hours. You should
purchase a spare bulb.
purchase a spare bulb.
When you see this message, please contact your local reseller or
service center to change the lamp as soon as possible.
service center to change the lamp as soon as possible.
Warning—To reduce the risk of personal injury, do not drop the
lamp module or touch the lamp bulb. The bulb may shatter and
cause injury if dropped.
lamp module or touch the lamp bulb. The bulb may shatter and
cause injury if dropped.
Warning—Lamp compartment is hot! Allow the projector to cool
down at least 30 minutes.
down at least 30 minutes.
To change the lamp module
1. Turn off the projector’s power by pressing the power button on
the Remote Control or Projector Panel.
2. Disconnect the power cord.
3. Use a screwdriver to remove the two screws from the cover.