Viking Huskylock 936 사용자 설명서
—6—
1-6. Replacing the needle
Turn the main power switch off.
1. Turn the handwheel toward you
(counterclockwise) by hand until the needle
is in its highest position.
2. Insert the needle into the opposite side
needle hole of Needle threader.
3. Loosen the needle set screw with allenwrench
and remove the needle.
Please be sure to tighten loosen set screws
after removing the needle.
Note: Please use the allenwrench included in
the standard accessories for the proper
installation.
IMPORTANT
Lightly tighten the screw at the unused needle
position, so it does not fall out while sewing.
To insert the needle
Turn the main power switch off.
1. Turn the handwheel until the needle bar is in
its highest position.
2. Insert the needle into the opposite side
needle hole of Needle threader as far as it
goes with holding the fl at side of needle away
from you.
3. Tighten the needle set screw with allenwrench.
4. If a needle does not go up all the way it may
be necessary to loosen the adjacent needle
screw slightly.