United States Stove 5040 사용자 설명서

14

THERMOSTAT INSTALLATION 

A thermostat may help you maintain a constant house temperature automati-

cally. A millivolt thermostat is required. A fixed wall mount or 

US Stove’s

 hand 

held model can be used. The control panel can be set up two ways to operate 

your stove in thermostat mode.

•    

•    Unplug stove from power outlet.

•    Remove control board from stove.

•    The two thermostat wires connect to the terminal block on the lower left 

      side of the back of the control board.

      (See figure 24)

•     Insert the wires in the terminal side and tighten the two screws.

TO SWITCH BETWEEN ANY OF THE THREE MODES THE STOVE MUST 

BE SHUT OFF, THE NEW MODE SELECTED, AND THE STOVE RESTART-

ED.

MANUAL  MODE

• 

•  In this mode the stove will operate only from the control panel as detailed 

in the 

“OPERATION” section of this owner’s manual.  

HIGH/LOW THERMOSTAT MODE

• 

•  When engaged in this mode the stove will automatically switch between 

two settings. When warm enough, it will switch to the #1 or low setting. 

The room air blower will also slow to its lowest speed.

•  The Heat Level Advance setting on the bar graph will stay where it was 

initially set. When the house cools below the thermostat setting, the stove 

will switch to the feed rate of the heat level advance setting.

ON/OFF THERMOSTAT MODE

• 

•  In this mode when the home is warm enough the stove will shut off. The 

fans will continue to run until the stove cools.

•  When the home cools below the thermostat setting, the stove will auto-

matically restart and run at the last feed rate setting.

NOTE: When in “high/low” or “on/off” thermostat mode –

•  Do not operate the stove higher than the #3 setting.

•  Set damper control rod approximately ¼” to ½” out. This will vary depend-

ing on elevation and weather conditions. Observe stoves operation and 
adjust damper as necessary.