Uniden BC95XLT 사용자 매뉴얼

43

To start chain search hold mode, press Hold in 
chain search mode. The scanner stops searching 
and 

 appears. In this mode, pressing 

 

Func +    changes the search direction downward 
and pressing Func +    changes the search 

 

direction upward.   or    appears according to the 
current search direction.

 

You can store frequencies you find in chain search 
mode or chain search hold mode.
1. Press Func + Pgm in chain search mode or 

chain search hold mode. The lowest blank 

 

channel and bank appear.

2. Press E to store the frequency into the blank 

channel. To select another channel, press Func 
+   or Func +    before you press E. You can 
also press 0-9 to select the bank.

If you try to save a frequency that is already stored, 
the scanner sounds an error tone and displays the 
channel that was duplicated. If you entered the fre-
quency by mistake, press  . To enter the frequency 
anyway, press E to accept.

The scanner sets itself to program mode after you 
store a frequency.

You can use this mode to define the search range 
used during a chain search in each search bank. To 
set the scanner to program band select mode, press 
Func and PSrc. SRCH appears. Then select a 

search bank.