Siemens TRAFFIC CONTROLS TC12 사용자 설명서

TC12 Installation, Commissioning & Maintenance Handbook

45 = Any lamp failure
46 = Any Red failure

Note: These bits are also set if the lamps are switched off at the controller. If

lamps

* =

t - used to provide a single

eply

48* = DFM

3 =

4 =

* =

oun

* =

oun

= Count/Occupancy/Queue Unit 2 output

= Count/Occupancy/Queue Unit 4 output

eue Unit 5 output

21*

Scoot lo

22*

Scoot loop 1 output

23* = Scoot loop 2 output

26*

Scoot lo

27* = Scoot loop 6 output

Scoot loop 11 output

49  =  unit 0, HIOCC alarm bit,
50  =  unit 1, HIOCC alarm bit,
51  =  unit 2, HIOCC alarm bit,
52  =  unit 3, HIOCC alarm bit,

54  =  unit 5, HIOCC alarm bit,
55  =  unit 6, HIOCC alarm bit,
56  =  unit 7, HIOCC alarm bit.
57  =  Serial data input

Note: 1) SCOOT loop allocations MUST be on either bit 0 or bit 4 of a reply byte.

The following three bits are automatically reserved for SCOOT, overriding
the previous configuration for these bits, hence giving a total of four reply
bits per SCOOT loop.

2) Functions marked * are NOT available for use with the GOL command.

dual controller monitoring is configured switching either controller
off will set these bits. If independent monitoring is required use separat

er.

group outputs allocated to each controll

bined direct input or OTU fault presen

bit for controller or OTU fault
failure indication

handset attached

Fault present in Log

t/Occupancy/Queue Unit 0 output

16
17*

t/Occupancy/Queue Unit 1 output

18* = Count/Occupancy/Queue Unit 3 output
19*
20* = Count

ccupancy/Qu

op 0 output

24* = Scoot loop 3 output
25*

Scoot lo

op 4 output

op 5 output

28*  =  Scoot loop 7 output
29*  =  Scoot loop 8 output
30*  =  Scoot loop 9 output
31*  =  Scoot loop 10 output
32*  =

53 = unit 4, HIOCC alarm bit,

666/HE/43100/000

Page 92

Issue 9