Siemens Boating Equipment M200D 사용자 설명서

 

Functions 

 

3.10 Trip reset 

M200D AS-Interface Basic 
Manual, 03/2009, A5E01668085-01 

41

 

3.10 

Trip reset 

Trip reset acknowledges all the faults that are currently present in the starter and that can be 

acknowledged. A fault can be acknowledged if its cause has been rectified or if it is no longer 

present.   
The trip reset can be triggered by: 
●  Remote reset via the bus interface (DO 0 CW ON and DO 1 CCW ON simultaneously) 
●  Local reset via the key-operated switch (0 position; order option) 
●  Local reset via the device interface (hand-held device) 
 

3.11 

Self-test 

Description  

Two types of self-test can be carried out: 
●  Self-test at startup 

This is automatically selected when the device is switched on or initialized. 

●  Self-test during operation: 

The motor starter monitors (cyclically) specific device components and signals any faults 

(device faults). 

Self-test fault 

If a fault occurs, the "DEVICE" LED lights up red. The fault can only be acknowledged by 

switching the device off and then on again. If the fault is still present, the self-test will return a 

fault again when the device is switched on. In this case, the motor starter must be replaced. 

 

 

Note 
Specific device components are monitored continuously (internally) by the motor starter and 

the results signaled with the message "Device fault".