Siemens Boating Equipment M200D 사용자 설명서

 

Installation / connection 

 

4.2 Connection 

M200D AS-Interface Basic 
Manual, 03/2009, A5E01668085-01 

57

 

Consumer connection on the motor starter 

For the assignment of X2, see Power terminal (Page 58): 
●  A flexible Cu cable with 1.5 mm

2

 or 2.5 mm

2

 

–  Without brake control: 3 wire + PE 
–  With brake control: 5 wire + PE 
–  With temperature sensor: 2 additional wires 
–  Han Q8/0 pin power connector 

 

Item 

Order no. 

Connector set, 8 X 1.5 mm

2

, 9 pin, complete with PG16 cable entry 

3RK1902-0CE00 

Connector set, 8 X 2.5 mm

2

, 9 pin, complete with PG16 cable entry 

3RK1902-0CC00 

4.2.3 

Installing and wiring power connectors 

 

DANGER 

 

Hazardous voltage 
Can Cause Death, Serious Injury, or Property Damage 
Before starting work, disconnect the system and devices from the power supply. 

 

Installa and wire the power connectors as follows:    

 

Step 

Procedure 
Route the cable through the cable gland, sealing insert (enclosed), and the connector housing. The sealing 

insert is available in the following gradings: 
Permissible external diameter of the cable 

Sealing insert 

1 

7.0 to 10.5 mm 

9.0 to 13.0 mm 

11.5 to 15.5 mm 

Green 

Red 

White 

2 

Strip the cable over a length of 20 mm. 

3 

Strip the cores over a length of 8 mm. 

4 

Secure the contact sockets/pins on the cores by crimping or soldering them. 

5 

Sort the contact sockets/pins in the socket/pin insert in accordance with the assignments (see section Power 

terminal (Page 58)). The contact sockets/pins should not engage yet. Make sure that they are correctly 

assigned. Push the contact sockets/pins into the socket/pin insert until they engage. Use a suitable tool to 

remove contact sockets/pins that have already been installed (Han Q4/2: 3RK1902-0AB00, Han Q8/0: 

3RK1902-0AJ00. 

6 

Make sure that the position of the coding is correct, pull the cable back, and secure the socket/pin insert in the 

connector housing using the cross-recessed screws enclosed. 

7 

Secure the cable gland. When doing so, make sure that the cable is not twisted against the connector housing.