Sears 486.24009 사용자 설명서
5
FIGUre 4
FIGUre 5
SPACER
WASHER
DRIVE PIN
1/8 x 1-1/2
COTTER PIN
COTTER PIN
WHEEL
WASHER
OFF
ON
1
2
3
4
6
7
8
9
10
5
FLOW
CONTROL
ROD
CONTROL
ROD
STEP 4: (SEE FIGURE 4)
•
Assemble a spacer, a washer, a wheel (air valve
facing out) and another washer onto the end of the
axle that has both the
facing out) and another washer onto the end of the
axle that has both the
large and small holes.
•
Install a 1/8" x 1-1/2" cotter pin into the small hole in
the end of the axle.
the end of the axle.
•
Open the bail on the drive pin and install it through
the wheel and the large hole in the axle. Close the
bail to lock the pin in place.
the wheel and the large hole in the axle. Close the
bail to lock the pin in place.
STEP 5: (SEE FIGURE 5)
•
Insert the end of the flow control rod with only one
bend into the hole in the lever on the flow control tube
assembly.
bend into the hole in the lever on the flow control tube
assembly.
FIGUre 6
STEP 6: (SEE FIGURE 6)
•
Turn the spreader upright on its wheels.
•
Hook the double bent end of the flow control rod
through the hole in the slide gate bracket located near
the bottom of the hopper.
through the hole in the slide gate bracket located near
the bottom of the hopper.
FIGUre 7
5/16 x 1-3/4
HEX BOLT
HEX BOLT
5/16 NYLOCK NUT
STEP 7: (SEE FIGURE 7)
•
Assemble the flow control mounting tube to the hitch
tube using two 5/16" x 1-3/4" hex bolts and 5/16"
nylock hex nuts.
tube using two 5/16" x 1-3/4" hex bolts and 5/16"
nylock hex nuts.
dO NOt tIGHteN Yet.