Sears 486.24009 사용자 설명서

•

Assemble the two 

INNer hitch braces to the flow 

control mounting tube using a 1/4" x 1-3/4" hex bolt 
and a 1/4" nylock hex nut. 

tIGHteN.  

•  tIGHteN all nuts and bolts assembled up to this 

point. 

•

For most vehicles, the hitch tube assembly should be 
left in the default position. 

•

Attach the spreader hitch to your vehicle hitch. 

•

Check for interference with the spreader directly 
behind and out to both sides of the vehicle. Lift the 
spreader at each position to make sure there is no 
interference with the spreader's flow control. 

•

If there is interference with the rear of the vehicle, 
extend the hitch tube assembly.

•

Calibrate the flow setting.  Follow the steps in order 
below.
1.  Push flow control arm to "OFF" position.
2.  Slide flow control mounting bracket along tube 

until closure plate in bottom of hopper just closes. 

3.  Snug the 5/16" nylock hex nuts just enough to 

hold flow control mounting bracket in place. 

4.  Set adjustable stop at "5". Pull flow control arm 

against stop. Verify that closure plate has opened 
about half way.

5.  If closure plate does not open half way, adjust 

position of flow control mounting bracket until 
closure plate will open about half way at "5" 
and will still close when arm is locked in "OFF" 
position. 

tighten the 5/16" nylock hex nuts.