Troy-Bilt 24A-070F768 사용자 설명서

�

�

����������

�

�

�

�

����������

����������

�����

1.  Remove the hairpin clips from the handle brackets and 

remove the carriage screws and wing nuts from the 
lower handle.
a.  Place the bottom holes in lower handle over the 

pins on the handle brackets and secure with 
hairpin clips. See Figure 2.

b.  Insert carriage screws through upper hole in lower 

handle from the inside and secure with wing nuts. 
See Figure 2.

2.  a. Unfold the upper handle until it aligns with lower 

handle. Make sure the rope guide is on the right 
side of upper handle. See Figure 3.

IMPORTANT: Make sure the cables are routed outside 
the lower handle. Also, do not crimp the cables while 
lifting up the handles.

  b. Secure the two handles by tightening the handle 

knobs (carriage bolts must be seated properly into 
the handle). See Figure 3.

3.  Pull the two cable ties attached to the cables tight 

approximately 8 inches from each cable end and place 
the cables into the cable guide.

4.  Loosen the wing nut that secures the rope guide to the 

right side of upper handle.
a.  Pull the starter rope out of the engine slowly. See 

Figure 4.

b.  Slip the starter rope into the rope guide. Tighten 

the wing nut. See Figure 4.

5.  a. Slide hose adapter of hose assembly into the 

base adapter located on the left front of the Yard 
Vacuum. See Figure 5.

  b. Pull spring loaded pin out on the base and align pin 

with the first hole (closest to the end of the tube) in 
the hose adapter. 

  c.  Release the pin to lock the hose in place.

Make sure the cables 

are routed outside the 

lower handle. Also, do 

not crimp the cables 

while lifting up the 

handles.

�

�