Trac Door model 988 & 988WL 사용자 설명서
©2005 TRAC-RITE DOOR, INC.
Page 8
Excessive force in operation may cause damage to
the door.
CAUTION
DOOR JAMB
DOOR GUIDE
BRUSH SEAL
Figure 13.
If the door is easy to close, but hard to open,
increase the spring tension. If the door is hard to
close, but easy to open, decrease spring tension.
NOTE!
15.2.1 Periodically clean any accumulated dirt from guides;
remove any debris from the guide channels at the floor.
remove any debris from the guide channels at the floor.
15.3 LUBRICATION: Lubricate the following every six months
or more in dusty and/or wet operating environments.
or more in dusty and/or wet operating environments.
15.3.1 Guides: Open the door. Spray silicone spray, Pledge™,
or Zep 45™ onto the door guide runners and inside the guide.
or Zep 45™ onto the door guide runners and inside the guide.
15.3.2 Lock: Spray the slide lock with silicone spray or
Pledge™ to promote smooth lock operation.
Pledge™ to promote smooth lock operation.
15.3.3 Chain Hoist Parts: Apply a small amount of oil to roller
chain.
chain.
16. REPLACEMENT PARTS
Part No. Description
Locks:
521226 Interior Lock Package
601811 SpaceGuard Latch Package
502705 SpaceGuard Lock
502721 Lock Out Key
Part No. Description
Locks:
521226 Interior Lock Package
601811 SpaceGuard Latch Package
502705 SpaceGuard Lock
502721 Lock Out Key
Hardware:
650080 Bracket, Universal, RH, LH
502680 42" Rope (8' - 10' tall)
508840 72" Rope (10' - 12' tall)
508841 90" Rope (over 12' tall)
651000 Steel Jamb Package (651005 w/ Windlocks)
651001 Wood Jamb Package (651006 w/ Windlocks)
651002 Concrete Jamb Package
650060 Axle Saddle w/ Tensioner
650070 Axle Saddle
650080 Bracket, Universal, RH, LH
502680 42" Rope (8' - 10' tall)
508840 72" Rope (10' - 12' tall)
508841 90" Rope (over 12' tall)
651000 Steel Jamb Package (651005 w/ Windlocks)
651001 Wood Jamb Package (651006 w/ Windlocks)
651002 Concrete Jamb Package
650060 Axle Saddle w/ Tensioner
650070 Axle Saddle
Springs:
650100 RH, 3.375" ID, 0.3125 wire, 49 coils, 15.63"
650110 LH, 3.375" ID, 0.3125 wire, 49 coils, 15.63"
650120 RH, 3.375" ID, 0.3125 wire, 68 coils, 21.56"
650130 LH, 3.375" ID, 0.3125 wire, 68 coils, 21.56"
600960 RH, 3.375" ID, 0.283 wire, 62 coils, 19.50"
650100 RH, 3.375" ID, 0.3125 wire, 49 coils, 15.63"
650110 LH, 3.375" ID, 0.3125 wire, 49 coils, 15.63"
650120 RH, 3.375" ID, 0.3125 wire, 68 coils, 21.56"
650130 LH, 3.375" ID, 0.3125 wire, 68 coils, 21.56"
600960 RH, 3.375" ID, 0.283 wire, 62 coils, 19.50"
Miscellaneous:
502290 Tube Astragal
521261 Felt Tape, 2”
502061 Guide Runner
502520 Draft Stop
504300 Touch-up Paint, Evergreen
504301 Touch-up Paint, Sunset Orange
504302 Touch-up Paint, Polar Blue
504303 Touch-up Paint, Royal Blue
504305 Touch-up Paint, Desert Tan
504306 Touch-up Paint, Continental Brown
504307 Touch-up Paint, Garnet
504308 Touch-up Paint, Iced White
50430A Touch-up Paint, Cedar Red
504325 Touch-up Paint, Shale
504323 Touch-up Paint, Bright White
502290 Tube Astragal
521261 Felt Tape, 2”
502061 Guide Runner
502520 Draft Stop
504300 Touch-up Paint, Evergreen
504301 Touch-up Paint, Sunset Orange
504302 Touch-up Paint, Polar Blue
504303 Touch-up Paint, Royal Blue
504305 Touch-up Paint, Desert Tan
504306 Touch-up Paint, Continental Brown
504307 Touch-up Paint, Garnet
504308 Touch-up Paint, Iced White
50430A Touch-up Paint, Cedar Red
504325 Touch-up Paint, Shale
504323 Touch-up Paint, Bright White
Operators:
651050 8:1 Reduced Drive Chain Hoist
651050 8:1 Reduced Drive Chain Hoist
14. OPTIONAL FIELD INSTALLED DRAFT STOP OR
BRUSH SEAL:
14.1 Place the door in the closed position before installing the
draft stop. Note that with the door down, the curtain may bow
slightly near the top towards the inside; this bowing is normal.
For the draft stop to be effective, it should follow the “bow” in
the door curtain so that it stays in contact across the entire
width of the door curtain. Starting at one end, attach to header
every 9 inches with appropriate fasteners. Cut to length if
necessary.
BRUSH SEAL:
14.1 Place the door in the closed position before installing the
draft stop. Note that with the door down, the curtain may bow
slightly near the top towards the inside; this bowing is normal.
For the draft stop to be effective, it should follow the “bow” in
the door curtain so that it stays in contact across the entire
width of the door curtain. Starting at one end, attach to header
every 9 inches with appropriate fasteners. Cut to length if
necessary.
14.2 Place the door in the closed position before installing the
brush seal. Position brush seal so that it just touches the flat
portion of the curtain. See Figure 13. Fasten brush seals to
jamb every 12 inches with appropriate fasteners.
brush seal. Position brush seal so that it just touches the flat
portion of the curtain. See Figure 13. Fasten brush seals to
jamb every 12 inches with appropriate fasteners.
15. MAINTENANCE
15.1 INSPECTION: Visually inspect the entire door monthly
for general cleanliness and ease of operation.
15.1 INSPECTION: Visually inspect the entire door monthly
for general cleanliness and ease of operation.
15.1.1 Inspect the guides and curtain for wear and/or accidental
damage.
damage.
15.1.2 Inspect all fasteners and anchor bolts for loose,
damaged, or missing parts.
damaged, or missing parts.
15.1.3 If door is equipped with a chain hoist mechanism,
inspect it for missing parts.
inspect it for missing parts.
15.2 CLEANING: No specific cleaning procedures are required
for your Trac-Rite rolling door. Clean as needed following
good housekeeping practices.
for your Trac-Rite rolling door. Clean as needed following
good housekeeping practices.