Osburn Stoves by SB I HYBRID 35 사용자 설명서
INSERT INSTALLATION
INSERT INTO EXISTING MASONRY FIREPLACE
NOTE: Follow pipe manufacturer’s instructions.
1.
Have the masonry chimney inspected by a qualified
chimney sweep or installer to determine its structural
integrity.
chimney sweep or installer to determine its structural
integrity.
2.
You will need a pipe length equal to the chimney height from
the hearth. If outside combustion air is to be used, you will
need a pipe length equal to the chimney height plus 18
inches
the hearth. If outside combustion air is to be used, you will
need a pipe length equal to the chimney height plus 18
inches
3.
Install a sealing cap at the top and bottom chimney
4.
You can install a fresh air intake as per Figure 24:
-
Option A through the floor
-
Option B through the back wall
-
Option C through chimney top
5.
Attach the DuraVent adapter, a section of pipe and clean out
tee, making sure the clean out tee is centered in the
chimney flue area. Use RTV, metallic tape, and a minimum
of three self-taping screws at all joint connections to ensure
a tight seal.
tee, making sure the clean out tee is centered in the
chimney flue area. Use RTV, metallic tape, and a minimum
of three self-taping screws at all joint connections to ensure
a tight seal.
*Minimum fireplace opening 22”L x 15”D x 19 1/2”H
Measure and build the chimney’s top sealing plate. Cut out holes for
chimney pipe and outside air pipe (if necessary). Install and seal with
flexible sealant to prevent water leakage. Install vent cap.
chimney pipe and outside air pipe (if necessary). Install and seal with
flexible sealant to prevent water leakage. Install vent cap.
FACEPLATE
Figure 22
Exterior dimensions
Figure 23
Exhaust & air intake position
7"
BOTTOM CHIMNEY CAP
TOP CHIMNEY CAP
VENT CAP
FLOOR
PROTECTION
PROTECTION
FRESH AIR INTAKE
(OPTION A)
FRESH AIR INTAKE(OPTION C)
FRESH AIR INTAKE
(OPTION B)
Figure 24
Venting & air intake setup
13