Osburn Stoves by SB I HYBRID 35 사용자 설명서
14
FACEPLATE ASSEMBLY
1- Install the damper rod as shown in Figure 25 & 26
2- Pull out the lead wires(Figure 27).Secure the top assembly with the 4 screws and insert the lid switch in the bracket at the rear of the
2- Pull out the lead wires(Figure 27).Secure the top assembly with the 4 screws and insert the lid switch in the bracket at the rear of the
right slide(Figure 28). Plug the white connector to the lid switch.
3- Run the wire with the black connector towards the front and secure it using the wire straps and fixation hole(Figure 27)
4- Assemble the sides to the top of the faceplate.(Figure 29)
5- Attach the faceplate extension to the stove. (Figure 30)
6- Install the control board on the upper right side of the faceplate(Figure 31). Slide the faceplate on the insert as shown in Figure 32
4- Assemble the sides to the top of the faceplate.(Figure 29)
5- Attach the faceplate extension to the stove. (Figure 30)
6- Install the control board on the upper right side of the faceplate(Figure 31). Slide the faceplate on the insert as shown in Figure 32
and secure it to the stove with 2 screws on each side.
7- Assemble the trim kit corners with L brackets and slide it down on the faceplate as shown in Figure 33. Use the U clip fasteners to
attach the trims to the faceplate.
8- Install the louvers assembly to the stove.(Figure 34)
9-
Install the decorative side panels on the unit (Figure 35)
DAMPER
CONTROL
CONTROL
ROD
SUPPORT
Figure 25
Damper rod installation
Figure 26
Damper rod installation
PULL THE
WIRES OUT
WIRES OUT
FIXATION HOLE
FOR PC-BOARD
WIRE
FOR PC-BOARD
WIRE
Figure 27
Lid switch and control board wires
LID
SWITCH
INSERT TOP
ASSEMBLY
ASSEMBLY
Figure 28
Top assembly