ONKYO CS-255 사용자 매뉴얼

24

If an iPod/iPhone is connected to the iPod dock, 
disconnect the iPod/iPhone from the iPod dock.

A USB flash drive cannot be used if an iPod/iPhone is 
connected.

Press the [iPod] button to select “iPod/
USB”.
Alternatively, you can use the CD receiver’s 
[INPUT] button.

1/3] button.

Selecting folders and files, and using the random 
play and repeat play functions, are the same as 
when playing back MP3 files from a CD (see 
page 18).

Note:
• Do not connect your USB flash drive via a USB hub.
• When connecting or disconnecting a USB flash drive, 

use your hand to support the CD receiver so that it 
does not move.

• For details on the usable formats for a USB flash 

drive, refer to page 12 “Playback from USB Flash 
Drives”.

• Even if a USB flash drive is connected to the USB 

port, the iPod/iPhone input will be selected if an iPod/
iPhone is connected to the iPod dock.

• Do not connect the CD receiver’s USB port to a USB 

port on your computer. Music on your computer 
cannot be played through the CD receiver in this way.

q]/[w] buttons to enter the 

current hour, and then press [ENTER].
When the CD receiver is shipped from the factory, 
the time display format is set to 24-hour time. Set 
the current hour as it would appear in 24-hour time.
If you want to set the current hour as 12-hour time, 
press the [DISPLAY] button.

q]/[w] buttons to enter the 

current minute, and then press [ENTER].
The clock is set and the second dot starts flashing.

Displaying the Time
To display the time, press the remote controller’s 
[CLOCK CALL] button. Press the button again or 
perform another operation to cancel the time display.

If the CD receiver is on Standby, the time will be 
displayed for about 8 seconds.

While the CD receiver is on, the time are displayed 
continuously.

Change the time format
To change the time format between 12-hour and 24-hour, 
press the [DISPLAY] button.

With Auto Standby, you can set the CD receiver so that 
it will be automatically turned off and enter the standby 
mode if there is no operation for 20 minutes with no 
audio input.

The default setting is “On”.

Make settings for this function while playback is 
stopped.

Press and hold down the remote 
controller’s [SLEEP] button (about 3 
seconds) to change the setting.
“AutoStby Off” (Off) or “AutoStby On” (On) 
appears on the CD receiver’s display.
To switch between “On” and “Off”, repeat this 
procedure.

USB flash drive