Nuance comm Server D60709-22 사용자 설명서
4 Using SafeCom Go Sharp
D60709-22
57
4.2.5
Copy
1.
If Copy Control is disabled (3.4.8) tap Copy / Scan … in the login screen
to start copy or scan. If Copy Control is enabled you have to login first
and then tap Copy / Scan … to start copy or scan.
to start copy or scan. If Copy Control is enabled you have to login first
and then tap Copy / Scan … to start copy or scan.
2.
Press the COPY button on the Sharp MFP to bring it into copy mode.
3.
Press the Start button to copy the documents placed in the automatic
document feeder (ADF). On some Sharp MFPs there are two Start buttons
- one for black/white copies and one for color copies.
document feeder (ADF). On some Sharp MFPs there are two Start buttons
- one for black/white copies and one for color copies.
Note: Once logged in to the Copy/Scan function the user cannot change to Pull
Print, unless the users logs out and logs in again. This is due to restrictions in
the Sharp MFP. Purchasing the Sharp Application Communication Module (MX-
AMX2) will remove this restriction.
Note: When a pay user begins copying, SafeCom Go Sharp uses the charging
scheme to calculate the equivalent number of mono A4 simplex pages the user
can copy with the available credits. If the user instead chooses to for example
copy A3 color pages the user can run into negative balance. Pages are counted
as they are printed and hence there may be an overrun of 4-8 pages.
Note: On Sharp AR-MXXX models SafeCom Pay is not recommended as there are
no means to stop the copy process when the user runs out of credits.
4.2.6
Logout
There is a configurable Timeout that defaults to 60 seconds. The logout
process is initiated if no buttons are tapped for this period. To logout actively:
process is initiated if no buttons are tapped for this period. To logout actively:
Tap Log Out on the main screen.
Use the card, if user logged in with card.
4.2.7
Register card with PUK code
The user goes to the device to login by entering an ID code or using a card. If
the ID code or card is unknown and there is an available PUK code in the
SafeCom system the user is asked to enter his PUK code.
Enter PUK code:
1.
the ID code or card is unknown and there is an available PUK code in the
SafeCom system the user is asked to enter his PUK code.
Enter PUK code:
1.
Tap PUK code.
2.
Enter PUK code on the touch-screen. Tap OK.
3.
Tap OK.
Enter PUK code and PIN code:
1.
Tap PUK code.
2.
Enter PUK code on the touch-screen. Tap OK.
3.
Tap PIN code.
4.
Enter PIN code on the touch-screen. Tap OK.
5.
Tap OK.