Kidde Fire Systems VEGA LT TM0081 사용자 설명서
TM0081
Page 43 of 51
Issue 1.01
Set-up
1.
Using the panel menu structure, locate the option Install repeater. This can be found from the top-level
menu under:
menu under:
Set → Standard features → Panel setup. Refer table 10.
2.
Change the option to ‘Yes‘.
3.
The main panel monitors active repeater panels attached to the system. The number of active repeater
panels has to be defined in the panel setup and is specified using the panel menu structure. Locate the
option Active repeaters. This can be found from the top-level menu under:
panels has to be defined in the panel setup and is specified using the panel menu structure. Locate the
option Active repeaters. This can be found from the top-level menu under:
Set → Standard features → Panel setup. Refer table 10.
4.
Enter the total number of active repeaters attached to the system.
Note, all passive repeaters attached to the main panel should be addressed at ‘0’. Active repeater
panels should be addressed in order from 1 to F. The address switch, SW 2 is located within the
repeater panel on card number 44782-K077-00.
panels should be addressed in order from 1 to F. The address switch, SW 2 is located within the
repeater panel on card number 44782-K077-00.
12.3
PRINTER ASSEMBLY- Part Number VR0053
Installation
1.
Ensure that the control panel is powered down. Disconnect the stand-by battery and then the mains
supply.
supply.
2.
Open the panel outer door and remove the printer blanking plate from the outer door.
3.
Install the VR0053 printer assembly as shown in Figure 38 using the fixings provided:
Figure 38: Printer Installation
4.
Using the 16-way ribbon cable supplied, connect printer interface card 44782-K050 PLG 2 to the MCP
card 44782-K071 card PLG 6.
card 44782-K071 card PLG 6.
5.
Using the cable supplied, connect the printer interface card supply terminals TB 1 marked 24V, 0v direct
to the 2.5A power supply output terminals.
to the 2.5A power supply output terminals.
6.
Power up the system. Apply mains supply first followed by the stand-by battery.
7.
Ensure that the Power On indicator LED D1 located on the printer interface card is illuminated.
8.
Press the ‘paper feed’ button located on the fascia plate to ensure that the paper is running free within
the printer mechanism.
the printer mechanism.
Set-up
1.
Using the panel menu structure, locate the option Install printer. This can be found from the top-level
menu under:
menu under:
Set → Standard features → Panel setup. Refer table 10.
2.
Change the option to ‘Yes‘.
3.
Locate the option Enable printer. This can be found from the top-level menu under:
Set → Printer status.
4.
Change the available options to read:
!
Printer Type
= Thermal
!
Printer status
= Enabled
5.
The printer will confirm that it is fully operational by printing ‘Printer installed’.