Invacare Electric Portable Patient Lift RPA600-1E 사용자 설명서
SECTION 2—ASSEMBLY
11
SECTION 2—ASSEMBLY
Assembling the Patient Lift
Assembling the Mast to the Base
NOTE: The mast assembly may be removed from
the base for storage or transporting. The mast
assembly MUST be properly secured to the base
assembly before use.
the base for storage or transporting. The mast
assembly MUST be properly secured to the base
assembly before use.
NOTE: For this procedure, refer to
FIGURE 2.1.
FIGURE 2.1.
1. Put the base on a level surface so all
casters make contact with the floor.
2. Lock the rear casters (Detail “A”).
3. Remove the shoulder bolt, nut and
washer, that secures the mast to the base.
4. Put the mast into the U‐shaped cut‐out in
the base.
5. While supporting the mast, insert the
shoulder bolt through the base, mast and
washers.
washers.
6. Secure the mast in place with a nut.
Washers
Shoulder
Bolt
Nut
Step Here
to Lock
Locking
Lever
DETAIL “A” -
LOCKING/UNLOCKING REAR CASTERS
Caster
Washer
Shoulder
Bolt
Nut
Step Here to
Unlock
Washer