Hughes HN7700S 사용자 설명서

 

Figure 4 shows the AC/DC power supply that is used with the HN 
router.        

In-line units The following instructions apply to AC/DC power supply with 

part number 1500089-0001. Refer to Figures 4 and 5. Connect the 
power supply as follows:

1. Connect the AC power cord to the power supply.
2. Connect the DC power cord to the DC IN port on the router, 

as shown in Figure 5 on page 13.

3. For an AC/DC power supply, make sure a suitable surge 

protector is available for the router.   

Do not connect the AC power cord to the surge protector at 
this time. Wait until you are ready to observe the router’s 
LEDs upon power-up.

Figure 4:   AC/DC power supply

• The input must be 110/240-VAC.

• A surge protector is recommended, whether you use an 

Note:

Protect the router with a suitable surge protector. 

Power surges are a common cause of failure for electronic 
devices.