Extech Instruments S4500THS 사용자 설명서
7
S4500THS User Guide
Portable Printing Solutions
Extech Instruments Corporation 285 Bear Hill Road, Waltham, MA 02451-1064 Phone: 1-877-4-EXTECH (439-8324) Fax: (781) 890-7864 Web site: www.extech.com
Copyright © 2005 Extech Instruments Corporation. All rights reserved including the right of reproduction in whole or in part in any form.
2.2 T
EARING
P
APER
:
The printer’s paper door acts as a tear bar. Pull one edge of the paper
against the tear bar as indicated, then tear down and across against the
tear bar to tear the paper.
against the tear bar as indicated, then tear down and across against the
tear bar to tear the paper.
Caution: The tear bar may have sharp edges.
Using the tear bar is the only way to tear the paper.
Pulling up and pulling sideways without using the tear bar can
cause a paper jam due to paper misalignment in the
print head mechanism
cause a paper jam due to paper misalignment in the
print head mechanism
F
IGURE
4: T
EARING
P
APER
3. U
SING
THE
P
RINTER
3.1 I
NITIAL
POWER
UP
AND
SELF
-
TEST
Once the Battery is charged and the paper is loaded perform a self-test:
Press the <On/Off> switch once. This turns printer on. LED #1 illuminates in
green, blue or orange depending on the mode of communication.
The printer will stay ON until it is manually tuned OFF.
If the printer is set for infrared communications (IrDA) mode the printer will
stay on all the time. Pressing the <On/Off> switch again will turn the
printer off.
printer off.
Press the <On/Off> switch to turn the printer off. The LED turns off.
To start the self-test, press and hold the <FEED> switch then press the
<On/Off> switch
The printer starts to print the self-test message. Release the <FEED> switch.
Press the <On/Off> or <FEED> switch to cancel the self-test print.
The first few lines of self-test Figure 5 show the printer firmware version, the
current printer settings (for example IrDA or Serial mode) and a list of any
optional or special features installed.
optional or special features installed.