Eventide DJ Equipment DSP4000B+ 사용자 설명서
The Harmonizer
Programmer’s Manual
The Harmonizer
Programmer’s Manual
Page 92 of 97
Release 1.2.1
1999 Eventide, Inc.
PARAMETER A
REA
M
ENU
P
AGE
P
LACEMENT
This section goes through a tutorial to show:
•
Certain modules that have userobject outputs are automatically connected to the head module upon
<insert>
ion.
•
The order of userobject connection to the head module affects
SOFT KEY
location in the
PARAMETER
area.
•
A null userobject connected to the head module or a menupage module does not appear in the
PARAMETER
area menu pages, but rather acts as a place holder.
Start with a “clean slate”
•
Load
Empty Program
from the “Utilities” bank.
•
Go to the Patch Editor area
(by pressing and holding the
PARAMETER
key)
•
Select the
misc
display mode by pressing the
<aud only>
SOFT KEY
three times. Select the module marked
hed
with
the
LEFT
or
RIGHT
CURSOR
key. Press the
<modify>
SOFT
KEY
. To the right is a composite image of what the
<modify>
menu looks like for the head module at this time.
Automatically connecting a userobject to the head module
•
Press the
<done>
SOFT KEY
to leave the
<modify>
menu for the head module. Press the
<misc>
SOFT KEY
twice to select the
aud+ctrl
display mode.
•
Press the
<insert>
SOFT KEY
and then the
LEFT
CURSOR
key. Turn the
KNOB
until the “
Delay
” group is shown.
Press the
RIGHT
CURSOR
key to highlight the allpass
module.
•
Press the
SELECT
key to go ahead with the insertion.
•
Press and hold the
PARAMETER
key to see that there is now a
menu page and
SOFT KEY
for the allpass module.
•
Go back to the Patch Editor area and select the
misc
display
mode and use the
<modify>
SOFT KEY
on the head
module. This is a composite of what the
<modify>
SOFT
KEY
can see in the head module now. This shows that the
allpass-obj userobject was automatically connected to the head
module.