Eventide DJ Equipment DSP4000B+ 사용자 설명서
The Harmonizer
Programmer’s Manual
The Harmonizer
Programmer’s Manual
Page 93 of 97
Release 1.2.1
1999 Eventide, Inc.
•
Go back to the basic Patch Editor area by pressing the
<done> SOFT KEY
. Now
<insert>
an easytaps module.
•
Return to the
PARAMETER
area and observe that there is
now a second
SOFT KEY
. This
SOFT KEY
is stacked because the
easytaps’ parameters take up more than one menu page.
•
Go back to the Patch Editor and use the
<modify>
SOFT
KEY
on the head module. Note there are now three
userobjects connected to the head module and that the new
userobject was connected after the existing two userobjects.
Adding a menupage module
This section demonstrates how an empty menu page shows up in
the
the
PARAMETER
area with a
SOFT KEY
.
•
<insert>
a menupage module (from the “
Interface
”
group).
•
Use the
<modify>
SOFT KEY
on the head module and
change the
obj1
specifier to
menupage-obj
.
•
Return to the
PARAMETER
area and observe that the
menupage
module has created a new menu page and that
the allpass and easytaps’
SOFT KEYS
were bumped
over when the null userobject was replaced.
S
TACKED
M
ENU
P
AGES
This section goes through a tutorial to show:
•
That modules’ parameters are presented on a menu page when their userobject outputs are connected to a
menupage
menupage
module
(which is in turn connected to the head module)
.
•
That multiple connections of the same module’s userobject output creates multiple “images” of the
module’s parameter(s).
module’s parameter(s).
Note: The second image of a module’s parameter(s) on the same menu page may not be active.
•
That menupage modules’ userobject outputs may be connected to other menupage modules to create
SOFT KEY
stacks.
Inserting Multiple menupages
•
Load
Empty Program
from the “Programming” bank.
•
Go to the Patch Editor area by pressing and holding the
PARAMETER
key.
•
Select
misc
display mode by pressing the
<aud only>
key three times.
•
<insert>
a menupage module from the interface group.