ADIC SNC 5100 사용자 설명서

For information about how to do this, see “Connecting to the 
Service Port” on page 95.

Press the Enter key on the service terminal.

If the prompt is not displayed, go to “Service Port MAP” on 
page 75.

Enter the 

fcShow

 command from the service terminal.

For more information, see the 

If the 

fcShow

 command does not display a Firmware State of 

Ready for the attached Fibre Channel SAN connections, go to 
“Fibre Channel MAP” on page 61.

If a Fibre Channel host should have access to SCSI Channel 
devices, verify that the FC port mode is Target.

The SNC 5100 Fibre Channel ports are set by default to Target 
mode. If the port mode for the host connection was changed to 
Initiator, the host will not be able to see the SCSI devices. 

For more information on setting Channel modes, see the ADIC 
Management Console User Guide.

If the host should have access to devices on a Fibre Channel, verify 
that the FC port mode is set to Initiator or Target and Initiator. 

If the port mode for the host connection is set to Target, the host 
will not be able to see the attached Fibre Channel devices. 

For more information on setting Channel modes, see the ADIC 
Management Console User Guide.

Enter the 

scsiShow 

command from the service terminal. 

For more information, see the