ADIC SNC 5100 사용자 설명서

Ethernet Port

To configure the network, connect to the SNC 5100 Service Port. 

For more information, see “Connecting to the Service Port” on 
page 95.

In all of the subsequent steps, substitute the values you determined 
in Step 6 of Table 2, “Pre-Installation Checklist,” on page 19.

Enter the 

hostNameSet

 command to set the Host name.

For more information, see the 

In the example shown, the host name of the SNC 5100 was 
“SN60023” and is now being set to “foster.” The shell prompt will 
change to reflect the new name.

Example:

SN60023 > hostNameSet "foster"

Target hostname set to foster

value = 0 = 0x0

foster >

Use the 

ethAddrSet

 command to set the host network address:

For more information, see the 

The IP address is specified as four decimal numbers, separated by 
periods.

Example:

foster > ethAddrSet "192.168.1.54"

Host Address set to 192.168.1.54 for Ethernet interface

value = 0 = 0x0