ADIC SNC 5100 사용자 설명서
Network Setup for the SNC 5100
89
6-00020-02
SNC 5100
If you need to set a netmask, specify it after the network address:
Example:
foster > ethAddrSet “10.0.0.2”, “255.0.0.0”
If you need a network route and/or default gateway, you must
specify it.
specify it.
Example:
foster > gateAddrSet "192.168.1.1"
value = 0 = 0x0
When more complicated routing is required, use the
route
command to specify the destination address, as a full address
(single host) or as an abbreviated subnet address.
(single host) or as an abbreviated subnet address.
Specify the address of the gateway that is reachable on the local
subnet.
subnet.
Example:
foster > route "add", "206.0.0", "192.168.1.1"
value = 0 = 0x0
Step 4.
Optionally, add User account for Telnet
If you want to access the SNC 5100’s command line interface
through its Ethernet port using a Telnet session, you need to add a
user account.
through its Ethernet port using a Telnet session, you need to add a
user account.
The user name you specify must be 3 or more characters. The
password you specify must be 8 or more characters.
password you specify must be 8 or more characters.
For more information, see the commands beginning with
user
in
Example:
foster > userAdd “username”,”password”
value = 0 = 0x0
foster >
Step 5.
Enter the
reboot
command to reboot the SNC 5100:
For more information, see the
.
Example:
foster > reboot