Boss Audio Systems GT-100 사용자 설명서

Within the effect chain, the point where the signal is split into channels 

“A” and “B” is called the “divider,” and the point where the two signals are 

recombined is called the “mixer .”
You can use the divider to switch between channels “A” and “B,” to assign 

strongly picked notes and softly picked notes to different channels, or 

to assign different frequency bands of your guitar sound to different 

channels .
The mixer lets you adjust the volume balance of channels “A” and “B,” 

place them in the stereo field, or slightly delay the sound of channel “B” to 

produce a spacious sound .

SINGLE

Use only one channel, either “A” or “B .”

DUAL

Use the two channels “A” and “B .”

Ch . A, Ch . B

Selects the channel to use .

OFF

DYNAMIC will not be used .

POLAR+

Only notes picked more strongly than the 

DYNAMIC SENS setting will be output .

POLAR-

Only notes picked more softly than the 

DYNAMIC SENS setting will be output .

0–100

Specifies the picking sensitivity .

OFF

The filter will not be used .

LPF

Only the region below the cutoff frequency 

will be output .

HPF

Only the region above the cutoff frequency 

will be output .

CUTOFF FREQ 100 Hz–2 kHz

Cutoff frequency

STEREO

Channels “A” and “B” will be mixed and output 

in stereo .

PAN L/R

Channels “A” and “B” will be assigned 

respectively to the L and R OUTPUT jacks .

100:0–0:100

Adjusts the volume balance of channels “A” 

and “B .”

*  This is shown only if DIVIDER MODE is set 

to “DUAL .”

0–100

Slightly delays the sound of channel “B” to 

make the sound more spacious .

*  This is shown only if DIVIDER MODE is set 

to “DUAL .”