Viper 3105V 사용자 매뉴얼
23
© 2012 Directed. All rights reserved.
Rapid resume logic
This Directed system will store its current state to non-volatile memory.
If power is lost and then reconnected, the system will recall the stored
state from memory. This means if the unit is in Valet Mode and the
battery is dis con nect ed for any reason, such as servicing the car,
when the battery is re con nect ed the unit will still be in Valet Mode.
This applies to all states of the system including arm, disarm, VRS, and
Valet Mode.
If power is lost and then reconnected, the system will recall the stored
state from memory. This means if the unit is in Valet Mode and the
battery is dis con nect ed for any reason, such as servicing the car,
when the battery is re con nect ed the unit will still be in Valet Mode.
This applies to all states of the system including arm, disarm, VRS, and
Valet Mode.
Power saver mode
Your system will automatically enter Power Saver Mode while armed
or in Valet® Mode, after a period of time in which no operation has
been performed. This lowers the current draw to the vehicle’s battery.
Power Saver Mode takes over under the following conditions:
or in Valet® Mode, after a period of time in which no operation has
been performed. This lowers the current draw to the vehicle’s battery.
Power Saver Mode takes over under the following conditions:
s
Power Saver when the system is armed: After the system
has been armed for 24 hours, the in-vehicle LED will flash at
half its normal rate, decreasing the system’s current draw.
has been armed for 24 hours, the in-vehicle LED will flash at
half its normal rate, decreasing the system’s current draw.
s
Power Saver in Valet Mode: When the system enters Valet Mode
the in-vehicle LED illuminates steadily. If the vehicle is not used (ig-
nition is not turned on) for a period of one hour while the system
is in Valet Mode, the LED will shut off. If the system remains in
Valet Mode, the LED will come back on the next time the ignition
is turned on and then back off.
the in-vehicle LED illuminates steadily. If the vehicle is not used (ig-
nition is not turned on) for a period of one hour while the system
is in Valet Mode, the LED will shut off. If the system remains in
Valet Mode, the LED will come back on the next time the ignition
is turned on and then back off.