Festool Guided Circular Saw PI561556 사용자 설명서

Supplemental Owner’s Manual 

23

The TS 55 REQ comes with an optional imperial depth gauge 

sticker to replace the standard metric depth gauge.
1.  Set the depth gauge pointer to its maximum setting.
2.  Using a sharp pencil, carefully mark the zero-depth posi-

tion of the depth gauge on the blade housing.

Mark the zero- 

depth position.

3.  Peel back no more than 1/3 of the paper backing from 

the top of the sticker. Peeling the paper back at a slight 

angle (as shown) will reduce the likelihood of kinking the 

sticker later.

  Important: Notice that the top of the sticker has the 

zero-depth indicator, and the numbers increase as 

they go down.

4.  Carefully position the sticker over the existing gauge with 

the zero-depth aligned with the pencil mark you made 

above, and straight along the edge of the blade cover.

Paper 

Backing

Align with 

pencil mark.

5.  Taking care not to kink the sticker, tuck the bottom under 

the depth gauge pointer.

6.  Make sure the sticker is properly aligned along the edge 

of the blade cover, peel back more of the paper backing, 

and press the sticker down.

7.  Raise the depth pointer back toward zero, peel back the 

rest of the paper backing, and finish adhering the rest of 

the sticker.

Peel back 

more of the 

paper backing.

Tuck the 

sticker under 

the pointer.