Festool Guided Circular Saw PI561556 사용자 설명서

24 

TS 55 REQ

Motor does not start 

 

►

Check that the cord is properly plugged into an outlet.

 

►

Make sure the Plug-it connector is properly inserted and fully tightened.

 

►

Make sure the outlet has power. Check the circuit breaker or try another outlet.

 

►

If used with a Festool dust extractor, make sure the selector switch is pointing to “Auto”. 

The auxiliary outlet on the dust extractor has power only when the selector is at Auto.

 

►

Inspect the power cord (including extension cords) for damage or missing prongs.

 

►

The motor brushes may have worn and need replacement.

The saw makes a 

“Growling” sound when 

it is first turned on or 

idling.

 

►

This is normal operation. Refer to 

The saw makes wavy 

cuts

 

►

Make sure the guide rail gib cams are properly adjusted.

 

►

Inspect the blade for damage.

 

►

Make sure the sole plate is not rocking on the guide rail.

 

►

Keep the blade depth consistent during the cut; don’t raise and lower the blade.

 

►

Forcing an ATB-type blade into the cut too fast can cause the blade to deflect.

Saw cuts are burning

 

►

Make sure to use the correct blade for the material.

 

►

Make sure the blade is sharp.

 

►

Make sure the blade is installed correctly (not turning backward).

 

►

Reduce the motor speed.

 

►

If possible, increase the blade depth.

 

►

Increase your feed speed.

Excessive chipping on 

the lower edge of the cut

 

►

Make sure to use the correct blade for the type of material and type of cut.

 

►

A very shallow blade depth can cause chipping on the underside if the teeth are barely 

protruding below the surface. Increase the blade depth.

 

►

The blade toe-in may be incorrect. Refer to 

Excessive chipping on 

the top edge of the cut

 

►

Make sure to use the correct blade for the type of material and type of cut.

 

►

Inspect the splinter guard. Make sure it is flush with the cut line for its entire length.

 

►

Materials prone to splintering may splinter more if the blade is set too deep.

The sawblade fails to 

retract after a cutting 

operation

 

►

The saw requires immediate service, and should be removed from operation. Contact 

Festool or your authorized Festool service provider.