Maxon Telecom Radio SP-300 Series Synthesized Scanning Radio 사용자 설명서
Antenna Installation
Attach the antenna by turning clockwise into the antenna receptacle
on top of the radio.
on top of the radio.
Installing and Removing the Battery Pack
Hold the radio face down in your hand. To attach the battery
pack, pick up the pack by the sides and hold it so that the latch is
facing upward. Place the bottom of the battery pack into the base
of the radio at approximately a 45
pack, pick up the pack by the sides and hold it so that the latch is
facing upward. Place the bottom of the battery pack into the base
of the radio at approximately a 45
o
angle. Gently push battery into
the radio back until the battery latch snaps firmly into place.
Remove the battery pack by holding the radio face down
in your hand. Press down and hold the battery latch. Holding the
latch with your finger gently pull battery out and away from radio.
in your hand. Press down and hold the battery latch. Holding the
latch with your finger gently pull battery out and away from radio.
Attaching and Removing the Belt Clip
The belt clip attaches to the radio's battery pack. To attach the belt
clip, hold the clip and slide it into the recessed area at the top of the
pack. A click will verify the clip is securely positioned. To remove
the clip, press and hold the release tab toward the clip while gently
pulling the belt clip assembly off the radio.
clip, hold the clip and slide it into the recessed area at the top of the
pack. A click will verify the clip is securely positioned. To remove
the clip, press and hold the release tab toward the clip while gently
pulling the belt clip assembly off the radio.
5