Maxon Telecom Radio SP-300 Series Synthesized Scanning Radio 사용자 설명서

NOTE: Federal Communications Commission Rules and Regulations

require that you monitor a channel for activity before transmitting.

NOTE: The tri-color LED located on the top panel can help with

channel monitoring. It will glow amber if RF activity is present; or

green if the transmission has a CTCSS or DCS tone that matches a

tone programmed for receive in your radio. When this LED is not

illuminated, the radio is indicating a "clear" channel.

2) When the channel is clear, hold the radio upright with the

antenna vertical and the front microphone area about 2-3 inches

from the mouth, keeping the antenna away from the face and eyes.

Press and hold the P-T-T bar on the side of the radio, and speak

slowly and clearly into the microphone area.

NOTE: The LED will glow red when transmitting. This indicator

should be on continuously while the P-T-T bar is being pressed

and the radio is transmitting. Should the red LED be "flashing", the

battery needs to be recharged and transmission will cease. Recharge

the battery before attempting more than one transmission.

Receive

When you have finished transmitting, release the P-T-T bar to

receive.

Power Off

When finished transmitting, receiving, monitoring, etc., turn the

radio off by rotating the on/off-volume control fully counter-

clockwise, to the detent position.