Samsung RF23HSESBSR 사용 및 관리

 

setting up

flat-blade screwdriver (-) Control Lever

Both control levers must be touching the 
floor to avoid possible personal injury or 
property damage because of tipping.

If the right side is lower, perform the same 
procedure, but with the right control lever.

It is difficult to remove the cover leg 
front from the refrigerator, so we do not 
recommend making small adjustments 
with the control lever. Instead, refer to the 
next page for the best way to make minor 
adjustments to the doors.

MAKING MINOR 
ADJUSTMENTS TO THE 
DOORS

Remember, a leveled refrigerator is necessary 
for getting the doors perfectly even. If you need 
help, review the previous section on leveling the 
refrigerator.

Adjustment 
part

Fixed part

The left door is fixed. To make minor door 
adjustments, adjust only the right door.

1.  Pull out the flex door ( 1 ) to reveal the lower 

hinge ( 

2 ).

2.   Insert the supplied allen wrench (5/32”) ( 3 ) 

into the shaft ( 

4 ) of the lower hinge.

3.  Adjust the height by turning the hex wrench 

( 

3 ) clockwise ( 

DOWN

 ) or counter clockwise 

( 

UP

 ).

When you turn the hex wrench counter-
clockwise (

), the door will move up.

3

1

2

3

4

INSTALLING THE WATER 
DISPENSER LINE

A water dispenser with a filter is one of the helpful 

features on your new refrigerator. To help promote 

better health, the water filter removes unwanted 

particles from your water. However, it does not 

sterilize or destroy microorganisms. You may need 

to purchase a water purifying system to do that.

The water line also connects to the ice maker.

For the ice maker to operate properly, water 

pressure of 20-125 psi (138 ~ 862Kpa) is required.  

If the refrigerator is installed in an area with low 

water pressure (below 20psi), you can install 

a booster pump to compensate for the low 

pressure.

After you have connected the water line, make 

sure the water storage tank inside the refrigerator 

is properly filled. To do this, press the water 

dispenser lever until the water runs from the water 

outlet.

Water line installation kits are available at 
extra cost from your dealer.  
We recommend using a water line 
installation kit that contains copper tubing 
and ¼” compression nut.

Connecting to the water supply line

1.  First, shut off the main water 

supply.

2.  Locate the nearest cold water drinking line and 

install the pipe clamp and shut off valve.