Samsung RF30HBEDBSR 사용 및 관리

English - 11

SETTING UP

REMOVING THE REFRIGERATOR
DOORS

For some installations you need to remove the
fridge and freezer drawers so you can move the
refrigerator to its ﬁ nal location.
Do not remove the doors/drawer if you don’t need
to. If you do not need to remove the refrigerator
doors, go to Adjusting the Level on page 15.
If you need to remove the doors. continue below.
Before removing the door/drawer, make sure you
read the following items:

WARNING

Disconnect power to the refrigerator before
removing the doors or drawers.

• Be careful not to drop, damage or

scratch the doors/drawers while
removing them.

• Use care when you remove the doors/drawers.

The doors are heavy and you could injure
yourself.

• Reattach the doors/drawers properly to avoid:

Moisture from air leakage.

Uneven door alignment.

Wasting energy due to improper door seal.

Disassembling the refrigerator doors

WARNING

Be careful not to drop and scratch the doors while
removing them.

With the door opened

1. Remove 3 screws holding down the TOP

TABLE ( 1 ) and separate the connected wires.

(1)

2. Disconnect two connectors ( 2 ) on the left side

door. To remove the water coupler from the
hinge, twist and pull it from the hinge.
Remove the water line ( 3 ) while pressing the
marked part ( 4 ) of the water line coupler.

(2)

(3)

(4)

Red Clip

Red Clip
(1/4")

(1/4")

CAUTION

If a red clip is on the coupler, you must remove it
before removing the tube.

3. Pull and remove the hinge lever ( 5 ). Remove

the ground screw ( 6 ) attached to the upper
left door hinges with a philips screwdriver (+).
Remove the upper left and right door hinges
( 7 ).

(5)

(7)

(6)

DA68-03030A-00.indb 11

2014. 3. 19.

9:48

2014. 3. 19.

9:48