Monogram ZIX30GNHII 디자인 가이드

80”

• Inside Top Face of bracket should be installed at 80”.

“Slot” in bracket should to be placed in center of install

Space (Typically 15”)                                                                            

• Mark (within slots, placement) stud and anchor positions

on brackets. 

•Secure bracket using combination of studs & anchors.      
•At least 1 stud must be engaged.However, please engage

as many studs as possible within the enclosure. A mininum
of three fasteners should be used for proper installation.

• Plug the power cord into the socket.
• Check to make sure power to refrigerator is on by

opening the ice drawer (FF door will be banded shut)
to see if interior lights are on.

• The temperature controls are preset at 37°F for the

fresh food section and 0°F in both the freezer drawer
and customizable drawer.

• Allow 24 hours to stabilize before making

adjustments.

• Position appliance in front of enclosure.
• Locate and bring tubing to the front of the cabinet.
• Turn the water on to flush debris from line. Run about

a quart of water through tubing into a bucket; then
shut off water.

If needed cut the tubing to the proper length so it can
be attached to the water valve.

Copper Tubing:
• Slip a 1/4" nut and ferrule over both ends 

of the copper tubing. Insert tube into the union fitting
on the unit and tighten nut to union.

• Turn on the water to check for leaks. 

GE SmartConnect™ Tubing:
• Insert the end of the tubing into the refrigerator

connection. Tighten the compression nut until it is just
hand-tight.

• Tighten one additional turn with a wrench.

Overtightening can cause leaks!

• Turn on the water to check for leaks.

Water

Line Hole

Slot