Bosch SPV68U53UC 작동 가이드

Press the [On/Off] button.

2      Select a cycle and desired options and press [Start].

Press and hold the [Start] button for approximately 3 seconds until the display reads “0:01”.

2      Wait about 1 minute while the dishwasher drains.
3      Press the [On/Off] button.

 

Press the [On/Off] button to turn the unit off.

2      To resume the cycle, press the [On/Off] button.

The amount of rinse aid dispensed can be set from “r:00” to “r:06”.

To change the setting:
1

Press the [On/Off] button.

2      Hold down the “A” button (see page 14) and press [Start] until the display indicates “H:00”.
3      Release both buttons.
4      Press the “A” button until the display shows “r:04”.
5      Press the “C” button to select the desired setting.

“r:00” = dispenser is OFF
“r:01” = lowest setting
“r:02” = low setting
“r:03” = medium setting
“r:04” = medium/high setting
“r:05” = high setting
“r:06” = highest setting

6      Press [Start] to save the setting.

You can delay the start of the cycle in one hour increments up to 24 hours.

To set delay start:
1

Press the [On/Off] button.

2      Press the [+] button until the display jumps to “h:01”.
3      Press the [+] or [-] button until the displayed time corresponds with your requirements.

h:01 = 1 hour delay 
h:24 = 24 hour delay

4      Press [Start] to activate delay start.
To cancel delay start:
1

Press the [+] or [-] button until “h:00” is indicated on the digital display.

2      Press and hold [Start] for 3 seconds to cancel the cycle. You may now start a new cycle.