Samsung FE-R300SB/XAA 사용자 매뉴얼
42_ Troubleshooting
PROBLEM
POSSIBLE CAUSE
SOLUTION
Oven not clean after
a self-cleaning cycle
a self-cleaning cycle
The oven controls were not set
correctly.
correctly.
See the section on self-cleaning on page
•
31.
The oven was heavily soiled.
Wipe up heavy spillovers before starting
•
the self-cleaning cycle. Heavily soiled
ovens may need to self-clean again or for
a longer period of time.
ovens may need to self-clean again or for
a longer period of time.
Steam from the vent When using the convection
feature, it is normal to see steam
coming out of the oven vent.
coming out of the oven vent.
This is normal.
•
As the number of racks or amount
of food being cooked increases,
the amount of visible steam will
increase.
of food being cooked increases,
the amount of visible steam will
increase.
Burning or oily odor
emitting from the
vent
emitting from the
vent
This is normal in a new oven and
will disappear in time.
will disappear in time.
To speed the process, set a self-cleaning
•
cycle for a minimum of 3 hours.
See the section on self-cleaning on page
•
31.
Strong odor
An odor from the insulation around
the inside of the oven is normal
for the first few times the oven is
used.
the inside of the oven is normal
for the first few times the oven is
used.
This is temporary.
•
Oven racks are
difficult to slide.
difficult to slide.
The shiny, silver-colored racks
were cleaned in a self-cleaning
cycle.
were cleaned in a self-cleaning
cycle.
Apply a small amount of vegetable oil to
•
a paper towel and wipe the edges of the
oven racks with the paper towel.
oven racks with the paper towel.
Display goes blank. A fuse in your home may be blown
or the circuit breaker tripped.
Replace the fuse or reset the circuit
•
breaker.
Display flashes.
There was a power failure.
Reset the clock.
•
Drawer does not
slide smoothly or
drags.
slide smoothly or
drags.
The drawer is out of alignment.
Fully extend the drawer and push it all the
•
way in. See the page 38.
The drawer is over-loaded or the
load is unbalanced.
load is unbalanced.
Reduce weight. Redistribute drawer
•
contents.
FE-R300_XAA DG68-00277A.indd 42
2010-01-20 �� 12:10:00