StorageTek 9714 사용자 설명서
Operating in Automated Mode
3-6
Eighth Edition
95698
If the operator panel displays “ONLINE - PRESS EXE TO UNLK CAP,” go
directly to the steps below.
directly to the steps below.
To gain access to the CAP so that you can remove a cartridge from it:
1. Press
EXECUTE
on the operator panel.
a. The operator panel displays “ONLINE CAP UNLK PENDING.”
b. The CAP drawer begins to slide toward you.
c. The operator panel displays “ONLINE CAP UNLOCKED.”
2. Pull the drawer further toward you. Hold onto the drawer.
3. Remove the cartridge and properly store it outside the LSM. Refer to
4. Slide the CAP drawer into the LSM. The lock automatically engages.
5. Repeat these steps until all the desired cartridges have been removed.
Replacing the Cleaning Cartridge
The following paragraphs pertain to you if your LSM has the AUTO CLEAN
feature enabled. You can use the View Configuration section of the block diagrams
in
feature enabled. You can use the View Configuration section of the block diagrams
in
to determine whether the feature is
enabled.
If the feature is not enabled, you will need to keep track of how many times a
cleaning cartridge has been used and throw it away when necessary.
cleaning cartridge has been used and throw it away when necessary.
When a cleaning cartridge has been used a number of times, as defined in
operator panel displays “CLEANING CARTRIDGE USED UP.” You must
remove the expired cartridge and place a new cartridge into the CAP. If your
machine has AUTO CLEAN enabled, use the procedure below to replace the
cartridge.
remove the expired cartridge and place a new cartridge into the CAP. If your
machine has AUTO CLEAN enabled, use the procedure below to replace the
cartridge.
Note: The Quantum DLT Tape Drive Product Manual recommends using a
cleaning cartridge about 20 times.
CAUTION:
Do not re-enter a cleaning cartridge that has been ejected from an LSM.
When you enter a cleaning cartridge, the software considers it to be new
and sets the usage counter to zero.
Do not re-enter a cleaning cartridge that has been ejected from an LSM.
When you enter a cleaning cartridge, the software considers it to be new
and sets the usage counter to zero.
Cleaning cartridges have a unique 3-character alphanumeric prefix in their
VOLSER (default is “CLN”). Cleaning cartridges cannot be used as scratch
cartridges or initialized by software utilities.
VOLSER (default is “CLN”). Cleaning cartridges cannot be used as scratch
cartridges or initialized by software utilities.